Cartridge Belt Wire management System

 

 

 

What is it?
The New Cartridge Belt wire management system is a Development by Fromeco.  Cartridge belts are ballistic nylon that is sewn to a Velcro backer in a way as to create a pocket or through hole.  This through hole can carry or fit many wires, Deans plugs, Fuel lines, Power Poles.   Cartridge Belts come in sticks of 6 pockets that are sewn together as one unit.  The individual pockets can be cut apart and mounted individually or can be cut in pairs of you have a large amount of wire going from one area of you Aircraft to another.   

Cartridge Belts are very light, and unlike other wire management systems they allow for more than wire to run, and because they are made out of the Nylon they do not chafe wires.  They can be also be bent around corners, or used to keep connected Deans connectors from Vibrating around in side of you Aircraft. 

Cartridge Belts can be especially useful inside of Helicopters, although there are no pictures of this on the site here, they do work great for wire management on Helicopters.

 

 

 

 

 

 

Shown to the Left is a Cartridge belt with 2 pockets cut off the main body of the belt.

 

 

 

 

 

 

 

 

 

 

 

 

Shown on the left is a cartridge Belt pocket with wire run through.  This example shows only 2 wires, the individual pockets can fit quite a bit more wire if needed.  Look further down the page for more examples.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

To the left is an example of the Cartridge Belt doing duty as an ignition high tension spark wire holder. 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Shown to the left is are Cartridge Belt pockets that are mounted directly to covering to hold down wiring.  

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Shown to the left are Cartridge Belt pockets holding down fuel tubing.  Cartridge belts can be used on practically anything that needs to be secured in your Aircraft as long as it will fit through the pocket.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Because Cartridge Belts are flexible the pockets can even be mounted in to corner areas if needed.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Shown to the left is an example of a Cartridge Belt area where a large patch of male velcro was layed down so that many wire runs could be achieved. 

This example has 3 Cartridge Belt packs that have been individualized, however they could have also be kept together as a group of 3 if needed.  Also in this example 3 Pockets were used to illustrate the Cartridge Belt, 2 pockets could have been utilized instead of 3.