Aircraft Regulators "The Regulator"

Service and Support

Contents

	Battery information
	Charger Information
	8 Ball Load Checker
	Aircraft Regulators "The Regulator"
	Aircraft Setup
	Aircraft Setup - 28 PERCENT and below
	Aircraft Setup - 30 PERCENT to 35 PERCENT
	Arizona Regulators
	Badger Switches
	Basic Instructions
	Battery Care
	Charging Questions
	Fromeco ReliaCharger
	Helicopter Questions
	Ion Cube Trouble Questions
	Kodiak Switches
	Miscellaneous Gathered Wool
	Operation Questions
	Other Chargers
	Peerless
	Pin Flag Switches
	ReliaRegulator (also Super Regulated ReliaSwitch)
	Relions
	Switch Information
	Wiring?

Aircraft Regulators "The Regulator"

Adjust the out put voltage of Fromeco Regulator

Jul/24/2007

How adjust the out put voltage of Fromeco Regulator. More

Are the two regulator outputs plugged directly into the rx?

Jul/24/2007

In your 35% setup using two rx batteries and two regulators, are the two regulator outputs plugged directly into the rx? Or must I make custom servo cables to split the regulator power amongst my servos? More

Can I use a 3 cell pack on a Fromeco Standard Regulator?

Aug/14/2007

I have a couple older Fromeco Regulators, and I was wondering if they can handle the voltage input that a three cell pack woudl have? The 4800 4 cell is a tad heavy for my Sceadu, and the 2400 only gives about 3 flights.

Q10093 - INFO- When adjusting the voltage on the std. regulator, please discuss the pros and cons of measuring the output voltage under zero load vs. some load.

Jul/24/2007

Q10096 - HOWTO- If using a 3-cell "Seiko Driver" Relion is there a regulator available to give a constant voltage such as 10 volts so you get a constant output from the servo?

Jul/24/2007

Q10107 - INFO- 2 Questions 1 Can I use an MPI 6 volt regulator with your batteries? 2 Are your peerless batteries safer to use than the relion?

Jul/24/2007

Q10114 - HOWTO- What is the correct way to set the regulator to 6.0 volts?????

Jul/24/2007

Q10144 - INFO- Regulators Voltage set point upon shipping.

Jul/24/2007

Q10176 - HOWTO- when you put a paper clip or screw driver to change the regulator-how do you know what setting you went to .and is using a 4800 for rx and 2800 on igni.-what settings would be best for 35 PERCENT plane 3d flying?

Jul/24/2007

Q10181 - INFO- Is it possible to run 2 of your batteries into one regulator then to the RX.

Jul/24/2007